No luck, still problems getting the zero point correct Do i need som special post processor for mastercan to run the programs?

[email protected]: The reason is that i find it fast and easy on most tasks, but on some parts i would like to run subs for engraving, or other standards that is often on different products. John Morris: Thanks, i will try that at work tomorrow.

Thanks for the reply. I dont think that is the problem since it is going 500-1000mm of the offset i have set in the mazatrol program it is running as a sub for. Do i need to somehow set my mazatrol to g54 f.eks and then run the sub with the same g54 code?

Thanks, i just did. Admin can delete this topic.

Hi, I have a problem getting the programs i make on Mastercam to work on the Mazatrol Matrix control on my machine. Mazak VTC-800/30SR What happens is that the coordinates are off(by a mile). Is there some trick i need to do on the Mazatrol? I run these programs as sub programs, and i thought it would use the coordines and zero i had from the main program, but it doesnt seem to work. Hope somebody can help me with this issue.

Hi, I have a problem getting the programs i make on Mastercam to work on the Mazatrol Matrix control on my machine. What happens is that the coordinates are off(by a mile). Is there some trick i need to do on the Mazatrol? I run these programs as sub programs, and i thought it would use the coordines and zero i had from the main program, but it doesnt seem to work. Hope somebody can help me with this issue.