Can I add that factor into setup sheet for cycle time ? Is there any way to manipulate the setup sheet cycle time?

Peck drill cycle time is reasonable in the machine simulation but it is significantly off in the setup sheet. Is there any solution?

Ivan, I sent it to you. i find some comment manipulation topic in this forum that you can break the comment with using special character maybe this can help https://www.emastercam.com/forums/topic/79766-comment-manipulation/page/2/ thanks again for your help

when i check with mp post for encrypted section it is basically come to end with this section if gcode_comm = 1006 & scomm_out <> snull, n$, pspc, *scomm_out, e$ when i made a change in this section it is changing the post output for the codes but I couldn't make it to place it at the different line as lack of my knowledge

Thank you for your respond @BehindYou When i debug it this is my result from NC output: |62||109|M5 M9 G4P.5 M51 S1222M3 G4P.5|pscomm_fmt_out[PST:362, 72]|plin$ + pncoutput + pscomm_all_out + pcomment_scan_out + pscomm_fmt_out + pspc Post: pscomm_fmt_out #set format and output of each Mastercam generated comment scomm_out = ucase(scomm_out) spaces$ = 0 if gcode_comm >= 1051 & sof & scomm_out <> snull, scomm_str, *scomm_out, scomm_end, e$ if gcode_comm = 1005 & scomm_out <> snull, n$, pspc, scomm_str, *scomm_out, scomm_end, e$, pfel if gcode_comm = 1006 & scomm_out <> snull, n$, pspc, *scomm_out, e$ if gcode_comm = 1007 & scomm_out <> snull, scomm_str, *scomm_out, scomm_end if gcode_comm = 1026 & scomm_out <> snull, *scomm_out if gcode_comm = 1008 & scomm_out <> snull, n$, pspc, scomm_str, *scomm_out, scomm_end, e$ spaces$ = sav_spc NC output: |63|T.MIN|109|-> M5 M9 G4P.5 M51 S1222M3 G4P.5|-> plin$[PST:4380, 7]|plin$ + pncoutput + pscomm_all_out + pcomment_scan_out + pscomm_fmt_out + pspc Post: ENCRYPTED POST SECTION colored blue lines are the responding lines for the codes but i can not see individual code in the post that i can manipulate like in your example what should I do? Thanks again...

In Advanced Drill toolpath at the code entry section i would like to enter more than one code. But in the post it generate all codes are in the same line. Can I get each code at the different line Example: ENTRY CODE: M5 M9 S1000M3 G4P1. G1 Z-.5 F10. M5 M9 S1000M3 G4P1. G1 Z-1.2 F5.