SEE ITS FINE IN THE BEGINING

OK I DID THE FIRST THING , BUT I CANNOT FIND THE SECOND SUGGESTION, CAN U POST A SCRERENSHOT OF WHERE IT IS?

So its been spitting out code with High feed rates, I would set it at 4., and it would jump to as high as 500. all over the place, doesn't make sense why it would do that. And also the angles would jump to 5000. Degrees and I think the Haas Mill is losing its accuracy, I have a part I'm make a spiral groove and the groove lost its track somehow, and I checked the collet and center, the part was very secure, It DID NOT spin inside the collet. I hope I explained that well, OI attached the File to review, I hop I can get some help because this is a typical Mastercam glitch that doesn't make sense. T-8441.mcam