Hi, I need to mill eliptic hole 20mm x 8mm. I am using 8mm mill to do it. Basically I would need the mill to enter 4mm from one side, travel 12mm and exit. How to do this? Thx

Do you have a sample?

Hi, one more thing. How to do this with a drill mode? For example; Hole is same size as a drill bit. How do I fast travel between holes in this case?

OK. This is acceptable. takes some time to optimise all toolpaths but it works. Big thanks to all of you.

Actually in your file I see that when going from upper hole to lower hole movement is in "linear feed" with feedrate 128. What I need is the machine to go to rapid movement between holes.

Hi, beginner question: I am milling a square tube and need to mill two circles one under another. Lets say the circle is 10mm diameter. How do I setup the parameters to mill the first circle and then go into rapid to reach lower circle. Right now I manage onlo to do it in feed mode but it is loosing too much time. Imagine having a 2meters long tube with 20 holes on all sides. Thanks