Hi that is not in my fanuc post or i can't find it, this post is for 6t older lathe. So i still need some help.

Thanks i will give that a try!!!

Hi how would i go about getting my post to put M42 on its own line/block in my post? This is how it outputs now all on one line G97 S498 M03 M42 My mori says you can't have two M codes on the same line. Thanks for any input!

Hi i did switch G2 and G3 around and i am using I & K so i will have to figure that out yet!!

Hi i changed dia_mult : -2 #Multiplier for output on X axis (Neg. switches sign of X) and it posts - X now!!! Do i have to switch G2 cw and G3 ccw to?

I know this is a old thread but how is this done? Do i just change the CW with CCW or something else? I just bought a old mori sl4 and it has X axis reversed compared to newer lathes. Plus what is posted above. sxg02 : "G2" #Circular interpolation CW sxg03 : "G3" #Circular interpolation CCW # -------------------------------------------------------------------------- # Motion G code selection sg00 : "G0" #Rapid sg01 : "G1" #Linear feed sg02 : "G2" #Circular interpolation CW sg03 : "G3" #Circular interpolation CCW sg04 : "G4" #Dwell sgcode : "" #Target string Also how is "I" on arc moves changed ?