We just upgraded to V9.1 from V7.2. We used to be able to contour a point. We used it to stop a dummy tool holder with a dowel pin for part location purposes. We added a few line of code to our old post: if t = 1, n, "G0 Z.1" if t = 1, n, "G1 Z-.375 F50." if t = 1, n, "M0" if t = 1, n, "G0 Z1." and it would post out the contour point location, g43 line, and the above code. Now in V9, whenever I attempt a contour point it (the contour operation) gets totally ignored by the post. I don't think it is the added code that is causing the problem because if I coutour a line with that tool (T1) it will spit out the contour operation and the code. Contour point just doesn't seem to work anymore. Any Ideas? Thanks, Aaron