Mousongie
-
Posts
4 -
Joined
-
Last visited
Content Type
Profiles
Forums
Downloads
Store
eMastercam Wiki
Blogs
Gallery
Events
Everything posted by Mousongie
-
MULTIPLE WCS (G54, G55) IN LATHE ENVIRONEMENT
Mousongie replied to Mousongie's topic in Industrial Forum
Thank you very much Peter Evans. Are you referring to the EDIT COMMON PARAMETERS table? -
Hi ! Here is the scenario :Im in a LATHE environment and I have a 250mm 9.84inch) long bar with a 30mm (1,18inch) diameter that i would like to clamp short in order to face and center drill (1ST OPERATION (G54) ) and after that unclamp and stick it out 200mm (7.87inch) and use a tailstock center to sustain the extreme side and then starting the turning of the bar with a new WCS (G55) (2ND OPERATION). To cut it short,IN MASTERCAM LATHE , HOW CAN I USE TWO DIFFERENTS WCS ( G54 and G55) in one setup?
-
Im machining a certain surface using PARALLEL with zigzag motion. However i would like to know if theres a way to prevent the tool from retracting in a rapid motion, between passes. Thanks in advance.
-
Parallel surface finish issue on Milltronics 6150
Mousongie replied to Goodwin1912's topic in Industrial Forum
Thank you for this useful info. I used to think that PARALLEL was the best selection for 3D sculpted surfaces. Would you please tell us what is the best ..... Thanks again!