nevermind

I get this error when posting tou hurco, always worked good other wise any suggestions? thanks charlie

We work with very small parts. Tolerances are tight. Within tenths. Prototype to small quanities of the same part. Repeatability would be eccentical.

Thinking of purchasing wedm, Currently run Mastercam6. Looking for input on what brand to look into. Thanks, Charlie

WE are attempting to cut custom 450 stainless using 3.250 dia carbide saws. The depth of cut is approx .055-065. The trick is we need to do this with very minimal burrs. When figuring the speeds and feeds using traditiional charts I get feed rates that are to high. These cutters have 128 teeth on them so that seems to be throwing me off. Can anyone offer any help on the speeds and feeds I should be using? Thanks Charlie

we did update from manufacturer it is a dell If I back plot one pocket it works fine, but if I back plot the transform of the same pocket the screen flashes continually

we just updated card that did not work the card is FX 540

We have a Nvidia Quadro FX card,however, the box was already deselected.

When I back plot, every time it moves to a new location get a strobe light effect. Did not change a thing, started happening out of no where. x3mu1 any suggestions? thanks Charlie

it was a spiral out pocket and after the first pocket it didn't continue to spiral out to the finished wall it left quite a lot of material. and I did not cut the first pocket twice or fit it

pocketing a small cavity and translating it 126 times,which I do every day. Today it cut first pocket correct the next 125 were undersize, so went back and posted same program this time all 126 are correct, didn't change anything except repost. Curios to as why this would happen? Charlie

Does any one use a benchmanxt? And if so what do you think of them,tolerances,etc. thanks Charlie

I do not have solids, but thanks for all the tips

version x2,mr2, level 3 bitmap is unchecked

mastercamx2 mr2 level 3