Frunple
-
Posts
9 -
Joined
-
Last visited
Content Type
Profiles
Forums
Downloads
Store
eMastercam Wiki
Blogs
Gallery
Events
Everything posted by Frunple
-
When using Geometry nesting, entities get colored as either Profile (green), Hole (red), or Ignore (grey). I have some holes that get colored grey. Why is this?? They should be red for holes. What does "ignore" mean in this situation? I'm assuming it's going to be ignored as a toolpath but it shouldn't be.
-
Might be a bug. Turns out it works fine when drawn in metric. Comes out tiny when drawn in imperial.
-
Trying to save some files as STL and a 4" x 5" piece saves as 3mm x 4mm...am I missing a setting?
-
Actually I figured it out. Looks like Mastercam will do just fine for what I need!
-
Today I made the whole thing out of an extruded solid. In the attached, the green is the solid, the purple is the surface I want to be the top and bottoms. Is there a way to "cut" away the part of the solid that are "outside" of the surfaces? I tried the solid/trim but that didn't work. Any other commands to do this?
-
I went about it another way. Not the exact way I was looking for it but I think it'll do. I'd be interested to see what you come up with though.
-
Can you explain the "chain to revolve"? Actually, they don't cross over, they are on different z depths so it looks like they cross but they aren't. Would there be an easier way to get the "knife edge" on this?? I was thinking of starting with an .75" extruded piece, and them trimming it to get the edges. Is that possible?
-
Yes, a top and bottom. Not sure why the surface direction would matter but ok, easy enough to change.
-
So I'm trying to teach myself Mastercam by using drawings that i've done with another program. So far so good I guess but I can't figure out how to surface one part I've made. I've attached it here. Can anyone shed some light on this? TEST.MCX-7
