Hello,

If you open your g code file with wordpad and hit find M01 and leave the replace all empty it will wipe all of them. 

I looked at the post a little for M133 M133 and didn't see anything that was odious.

Hello and thank you for this update. I did figure this out. When I'm back at work I will post the code. Unfortunately MasterCam X9 is posting the NC code incorrect along with the spindle direction being M134 as cw? It will be obvious when I post it.

Found that ref. point check box right next to the snake bite kit. So funny when the answer is right in front of me.

Thanks for the direction.

Cheers

I did create a point. Then used it for user defined. Is that that the same as Ref. point?

I did notice that when I posted it out it did not use that user defined point. The posted code did a diagonal move from home to the part face.

G00 G54X5.1355 Z 085

Well I figured it out. All I had to do is edit the Home Position to X7.0 Z1.0 and the turret will move to that point first. Then down in X to the start .100" lead in amount.

Cheers

Hello all,

I just got this machine with mastercam X9 recently. I'm running into a programming problem. I know I want the turret to move Z first for tailstock clearance. I'm using the GENERIC HAAS ST 4X MT_LATHE control that came with the tailstock defined within it..

any suggestions?