TiGuy
-
Posts
7 -
Joined
-
Last visited
Content Type
Profiles
Forums
Downloads
Store
eMastercam Wiki
Blogs
Gallery
Events
Everything posted by TiGuy
-
Dumb Question: How to remove Opt Stop at tool change?
TiGuy replied to svirfnebli's topic in Post Processor Development Forum
Hello, If you open your g code file with wordpad and hit find M01 and leave the replace all empty it will wipe all of them. -
I looked at the post a little for M133 M133 and didn't see anything that was odious.
-
Hello and thank you for this update. I did figure this out. When I'm back at work I will post the code. Unfortunately MasterCam X9 is posting the NC code incorrect along with the spindle direction being M134 as cw? It will be obvious when I post it.
-
Found that ref. point check box right next to the snake bite kit. So funny when the answer is right in front of me. Thanks for the direction. Cheers
-
I did create a point. Then used it for user defined. Is that that the same as Ref. point? I did notice that when I posted it out it did not use that user defined point. The posted code did a diagonal move from home to the part face. G00 G54X5.1355 Z 085
-
Well I figured it out. All I had to do is edit the Home Position to X7.0 Z1.0 and the turret will move to that point first. Then down in X to the start .100" lead in amount. Cheers
-
Hello all, I just got this machine with mastercam X9 recently. I'm running into a programming problem. I know I want the turret to move Z first for tailstock clearance. I'm using the GENERIC HAAS ST 4X MT_LATHE control that came with the tailstock defined within it.. any suggestions?