The X+ setup sheets is a step in the right direction. Thanks.

By hand I've done 1000 lines max, must being in the 200-300 range. I could normally layout the toolpaths in 5 to 10 sheets. The operators needed the sheets the work the bugs out of the program to first time around. The free backplotter was good for being free but didn't help catch everything. I was good for a transposed digit or two. The time to generate these sheets and then write the code made it easy to justify mastercam. I personally don't think they need the sheets with the mastercam programs, but if I could figure out how to whip them up something like they are use to in a few minutes it would make them happy.

Hi. I am looking for toolpath sheets ideas. We use to program by hand and would lay the toolpaths out in cad point by point. These sheets were part of the packet the operators got. They are complaing the mastercam setup sheets aren't enough. Is there any addons to dimension the toolpaths or a seperate program that I can run the code through to do this. I'm considering puting the free backplotter I use to use on their computer.