Haven't done yet only made drawing what I posted. I need to know how to cut this on od may be using sweep or extrude not sure..

Hlo everyone

I would like to cut the profile inside the circle around the circumference.  Any help ..

thanks 5th axis CGI for your video 

I ll try 

thanks for your suggestion

so far my knowledge says I can draw od & revolve to make it solid but do not know how to cut blades after that

hello everyone

I am looking to make drawing.

toolpath should be easy I am hopin.

on cad I want to make this .

hello  everyone

Trying to cut  helix profile on OD, can t do it . looking for any suggestions.

if it was straight cut then I can cut on sweep option now I do no know how to cut on an angle on OD.

Attached part

hello everyone 

trying to make radius of 0.5 & cannot make it on both ends.

any help ...

Hello 

I have same issue when i draw toolpath it only runs on too diameter when o select first & last entity but my part have undercut profile in the middle it does not cut in middle .

Any help

Regrads 

Sunny

thanks alot

i will try...

Hello 

I try to create a ring .

I created half cut section as in attachment but i want to make a shape the way its going to look .

I try to revolve but after selecting section it ask me line of axis where to revolve i want around origin.

Any help 

Regards 

Sunny

thanks a lot i will try 

Hello

I am able to create bottom preview suppose to make top one in the attachment.

Any suggestions

Thanks

thanks

msg i recieved you are not permitted to upload this kind of file.

any suggestions ?????

thanks for your reply. i tried to upload but it says this file is not supported.....

hello i want to upload one of my practice drawing to discuss the toolpath. how i can do this.

Thanks for your answer.....

thanks everyone for your suggestions....... 

i have confusion about construction mode says 2D or 3D. when we suppose to pick each option......

how to transfer geometry from top plane to front plane , i have created geometry in top plane but i suppose to do this on front plane.

any suggestions.