I compared the pages to 2022 and they are both the same

recently upgraded to Mastercam 2023. I programmed a hybrid and tool path looked good. When I ran thru verify, It shows tool holder crashing thru part. Ran back plot and looked at path from front view and it shows huge arcs in the XZ. I could not get it fixed, so I ended up programming my second op in 2022 using the same toolpath and parameters with no issue. I ran into the same issue on another part with an area rough. I was able to change the direction of the containment and it worked. I went back to the original part that had an issue and tried repicking the containment in a different direction, different containment and no containment, with no resolution to the crashing in verify. Anyone else had this issue? When i first had the problem, I reran the migration wizard to see if this helped, but it didn't