George Vassilev
-
Posts
17 -
Joined
-
Last visited
Content Type
Profiles
Forums
Downloads
Store
eMastercam Wiki
Blogs
Gallery
Events
Posts posted by George Vassilev
-
-
Not the best solution, but if the model allows use scallop instead there is a switch go in/out site. Hybrid doesn't have it.
-
If you changing the rad of the tool , might be better to programme with Tip compensation to center not the tip of the tool
- 1
-
look under viewsheets
-
You have to open the editor from Mastercam.From main menu go to file edit then click on Editor and select MC Edit, if you trying to open from Windows you will get the message
-
Open the file with NC Editor (it is supplied with MC) go to nc utils and Scale the nc prog.
-
the editor also can do it.Go to transmission on the menu ,DNC setup, setup, baud rate, can go up to 256000.
Hope this helps George
-
Did you try create/surface/trim_extend/fill holes
-
convert the parametric spline to NURBS and then apply the contour with cutter comp. off
-
Hi Jeff,
if you want to use Rough op. in Lathe for grooving
be sure that under Rough parameters in the op. plunge parameters are set correct to allow plunge
hope this helps
George
-
maybe your grid is turned on try Alt+G and uncheck
visible grid
hope this helps
George
-
Under Finish contour parameters use Cut_depths
-
In XP you can use James tip , instead access the DOS though Mastercam go to File, Next menu, Dos shell and type the same
command line :ren c:filepath*.mc7 *.mc8
George
-
Hi Larry,
most of the dealers are offering update training, I thing this is good way to start save time and headaches
regards George
-
You can use Flow5ax ,works well on shape like this
-
also you can use xform/scale to adjust the size of the letters and keep the associativety between toolpath and geometry
George
OptiRest milling start from outside?
in Industrial Forum
Posted
rest mill is usually follows previous operation, but if you want to change it turn off the stock /rest switch, go to the toolpath control tab change it and then turn on the rest mill under stock