George Vassilev
-
Posts
17 -
Joined
-
Last visited
Content Type
Profiles
Forums
Downloads
Store
eMastercam Wiki
Blogs
Gallery
Events
Everything posted by George Vassilev
-
rest mill is usually follows previous operation, but if you want to change it turn off the stock /rest switch, go to the toolpath control tab change it and then turn on the rest mill under stock
-
Not the best solution, but if the model allows use scallop instead there is a switch go in/out site. Hybrid doesn't have it.
-
If you changing the rad of the tool , might be better to programme with Tip compensation to center not the tip of the tool
-
Strange background color issue in X4?
George Vassilev replied to neurosis's topic in Industrial Forum
look under viewsheets -
You have to open the editor from Mastercam.From main menu go to file edit then click on Editor and select MC Edit, if you trying to open from Windows you will get the message
-
Open the file with NC Editor (it is supplied with MC) go to nc utils and Scale the nc prog.
-
the editor also can do it.Go to transmission on the menu ,DNC setup, setup, baud rate, can go up to 256000. Hope this helps George
-
Did you try create/surface/trim_extend/fill holes
-
convert the parametric spline to NURBS and then apply the contour with cutter comp. off
-
Hi Jeff, if you want to use Rough op. in Lathe for grooving be sure that under Rough parameters in the op. plunge parameters are set correct to allow plunge hope this helps George
-
maybe your grid is turned on try Alt+G and uncheck visible grid hope this helps George
-
Under Finish contour parameters use Cut_depths
-
In XP you can use James tip , instead access the DOS though Mastercam go to File, Next menu, Dos shell and type the same command line :ren c:filepath*.mc7 *.mc8 George
-
Hi Larry, most of the dealers are offering update training, I thing this is good way to start save time and headaches regards George
-
You can use Flow5ax ,works well on shape like this
-
also you can use xform/scale to adjust the size of the letters and keep the associativety between toolpath and geometry George
