pmcamnw
-
Posts
6 -
Joined
-
Last visited
Content Type
Profiles
Forums
Downloads
Store
eMastercam Wiki
Blogs
Gallery
Events
Posts posted by pmcamnw
-
-
I did the same bob.but since its been out in the public beta and heard good things about it.i installed the public release
right away and so far its been good.the only issue I have ,and I know you use vericut so for you it doesn't matter,but my machine
simulation is behaving a little weird.i already contacted shopware about this issue just waiting to hear from them.
A work-around for the X8 MachSim issue is to go into the Control Definition and if it is set for dog-leg rapids, set it for "All axis arrive at destination simultaneously", in the Linear section.
-
Went post by post and found it. Adding the * before A, B parameter, worked great.
Thank you
-
Thanks for the welcome!
I did try a search before posting and have done so again without finding info on this specific question.
I am amazed at the shared knowledge on this forum.
Could you point me to the post that addresses this.
Thanks
-
First time posting a question, but have learned a lot from this forum.
Can someone tell me if it is possible to get a post to force an A B rotary address for every work offset move.
I have a dual 5c Haas 5 axis trunnion. The fixtures in each spindle do not align perfectly on B axis. So when I am using the same tool on both rotary spindles, I need the spindle to index to the correct orientation as I move between the two. Currently the post positions the first spindle and then thinking the second spindle is already oriented outputs the G54.1 x y only.
This is what it is doing.
M13
G0 G54 G90 X-.6162 Y-.0375 B0. A0. S8000 M3
M10
M12
G43 H1 Z8. T2
Z7.3
...
Then does a work shift to other spindle to run the same toolpath on second part.
G0 Z8.
G54.1 P105 X-.6162 Y-.0375
Z7.3
...
This is what I want it to do
M13
G0 G54 G90 X-.6162 Y-.0375 B0. A0. S8000 M3
M10
M12
G43 H1 Z8. T2
Z7.3
...
Then does a work shift to other spindle to run the same toolpath on second part.
G0 Z8.
G54.1 P105 X-.6162 Y-.0375 B0. A0.
Z7.3
...
Any help would be greatly appreciated.
Paul
Importing tool holder as a solid model
in Industrial Forum
Posted
So What is the proper orientation for this holder to work on import.
I have tried dxf, step, and mcam files. none read in without error.
I created the profiles in the top plane quadrant 1of coordinate system.