Thanks Colin, I sent them an email!

Thanks for your help Colin. I opened the post file in editor and I searched for "use_only_tl" and nothing was found. Any further advice? Let me know what you think!

Phenomenal, thank you both! I will try your suggestions later today and report back.

Bump

Good Afternoon, I'm having an issue determining how to configure the Z axis on the sub spindle on Mastercam 2020 (Nakamura NTY3). For example: I am trying to perform a drilling operation using the lower right turret. To do so, I select the axis combination shown in the attached image. However, the shown axis combination cause the +Z direction to face into the part; which is inverse to our machine. I have searched the forums and similar post have lead me to the attached code as being the solution. But, I do not know how to get to the code attached. Help on this situation would be fantastic. Thanks!