Dixon113a
-
Posts
5 -
Joined
-
Last visited
Content Type
Profiles
Forums
Downloads
Store
eMastercam Wiki
Blogs
Gallery
Events
Everything posted by Dixon113a
-
ok the post works to output the code but i can not still get the tool path in mastercam to helix into the part.I am trying to cut a 17.732 dia. pocket with a 2 deg slop on the bottom.Pocket starts at .479 deep on one side tapers 2 degs to the other side.The tool path mills around till it gets to .479 depth and then works its way to the deeper side in steps.Like to have is helix all the way around the part to finish sides and bottom
-
Hello, I cant get the mill to post an X,Y,Z move all in the same line not sure if it the tool path I gave it or what I am doing wrong. Trying to cut a circle with a 2 deg slop on the bottom. I know the machine will do it. What tool path in surfaces is the one I would need. Did it as a contour.
-
Yes it worked fine thanks for the help.
-
The Line is a red that says( 708 Incorrect G-code). Where and what do I need to do with the Macro for the G126
-
Hello, I am have a problem when I post. The code that I am get will not run in the machine this is the code O1000 ( BEADFEEDER ) G20 ( TOOL - 23 OFFSET - 23 ) ( 2" FACE MILL ) G17 G53 M302 G28 Y0. G28 U0. W0. M200 M01 T2323.00 B40 G97 S850 M203 M250 B20. M251 G126 X0. Y0. Z0. R0 S0. G0 X4.8052 Y-3.6546 Z.9115 C90. M9 the program stops at the G126 right after it locks the b-Axis with the 251. Can some one tell me what I am doing wrong thanks