shawng57
-
Posts
3 -
Joined
-
Last visited
Never
Content Type
Profiles
Forums
Downloads
Store
eMastercam Wiki
Blogs
Gallery
Events
Posts posted by shawng57
-
-
Greg,
Program like you normally would but us a ball endmill or a bullnose. It's just a matter of how you pick up the endmill off of the radius to get back to the center of the endmill. Pick-up on a known face that you know where it is from X or Y and then dial back over to your zero. A ball endmill works the easiest. Good luck
Shawn
-
Go to Mastercam.com and under corporate there is another tab for employment. They have job openings around the USA and Canada.
TOMBSTONE PROGRAMMING
in Industrial Forum
Posted
SMO,
Go to shopwareinc.com and look under downloads. Below the Technical doc's,Drivers, & examples section there is a horizontal tutorial and a horizontal part set-up procedure. Check these out. Hope this helps. Have a good day