SMO, Go to shopwareinc.com and look under downloads. Below the Technical doc's,Drivers, & examples section there is a horizontal tutorial and a horizontal part set-up procedure. Check these out. Hope this helps. Have a good day

Greg, Program like you normally would but us a ball endmill or a bullnose. It's just a matter of how you pick up the endmill off of the radius to get back to the center of the endmill. Pick-up on a known face that you know where it is from X or Y and then dial back over to your zero. A ball endmill works the easiest. Good luck Shawn

Go to Mastercam.com and under corporate there is another tab for employment. They have job openings around the USA and Canada.