Search the Community
Showing results for tags 'Okuma MU400'.
Found 1 result
-
Good morning all. We recently purchased an Okuma MU400VA. I'm trying to determine what will be the best post/verification solution for us. Currently I'm running a trial on the Mastercam post from our reseller which is working well. Verify is matching what is output, but so far mostly 3+2. I am currently programming a part that I've used a Surface Highspeed OPTI Rest toolpath and then using Convert to 5ax. Verify looks great. No gouges. However when I post it gives me unwind/retract warnings. I'm apprehensive about this after reading about some issues with this here. We have looked at ICAM. It looks very good, but I've also read here that it doesn't solve all the problems. There seem to be lots of positive comments about Vericut. I haven't had a chance to look at that yet but I think I will try to find a reseller on my area and try to have a demo of this. Can anyone offer opinions or advice in this respect? Anyone else using Mastercam with an Okuma MU400VA? What verification/post setup are you using? Thanks,
