Register now to participate in the forums, access the download area, buy Mastercam training materials, post processors and more. This message will be removed once you have signed in.
Use your display name or email address to sign in:
I have searched the forums on how to enable HPCC in the post, but I have only found this thread: http://www.emastercam.com/board/topic/71735-aicc-g05q1-how-to-enable/?hl=hpcc#entry834720
It is helpful, but only shows where to enable HPCC in the misc values tab from within the parameters of a given toolpath. However, I see that there is a check box on the misc values tab that says 'Automatically set to post values when posting'. Is it possible to configure the post so that HPCC will be automatically turned for all toolpaths that support it, instead of having to individually enable each toolpath?
Also, I did post out a toolpath with HPCC enabled in the misc values tab, but G05 P10000 was added after G43 -- Aren't all tool length offsets supposed to be canceled before HPCC is enabled, which would mean that g05 P10000 should go before G43?
thanks
Bret
eMastercam - your online source for all things Mastercam.
Together, we are the strongest Mastercam community on the web with over 56,000 members, and our online store offers a wide selection of training materials for all applications and skill levels.