Mastercam2018

[CRISTIAN17]

Hi everyone,

Maybe someone can orientate me on this one.

I was using Mastercam 2018,  and on the Optirough toolpath, under "cut parameters", the boxes for "stock to leave on wall" and "stock to leave on floor"  where not showing anywhere, and I went through the entire menu of that toolpath, but nothing.  
Tried a 2D HS toolpath, and that one does show those boxes. 

Any idea what can cause this phenomenom?  And possible solution to fix it, if its fixable.

[crazy^millman]

They are not the same toolpath so they don't have the same parameters in the same places. Go back to the Model Geometry and you set them in that page.

 

Welcome to the forum and have a good night or day depeding on what part of the world you are in.

[CRISTIAN17]

Oh man!! completely overlooked that area.   Thanks for brighten my day.

Im in Anaheim, CA btw.   Cheers!

[crazy^millman]

5 minutes ago, CRISTIAN17 said:

Oh man!! completely overlooked that area.   Thanks for brighten my day.

Im in Anaheim, CA btw.   Cheers!

I work with CCCS so if you get stuck you can shoot me an email. I will send you my private email through PM encase you need help with something.