4th axis sub feedrate zero

[Born to machine]

Hi All,

Is there a way to stop the output of z0. feedrate eventhough my parameters say otherwise?

Im only getting a few of these zero feedrated every now and again and im also getting some very slow feedrates sat 1.0 mm per min then it speeds up again..

Can i override the feedrate to a minimum?

Using 2021 here..

Thanks

 

[Guest]

4 hours ago, Born to machine said:

Hi All,

Is there a way to stop the output of z0. feedrate eventhough my parameters say otherwise?

Im only getting a few of these zero feedrated every now and again and im also getting some very slow feedrates sat 1.0 mm per min then it speeds up again..

Can i override the feedrate to a minimum?

Using 2021 here..

Thanks

 

There's a bug on the finishing pass for circle mill/helix bore I've seen, I also had a corrupted operations file cause all my pocket operations to output f0.

If you could post an example, we could probably narrow it down a bit.

[Born to machine]

Thanks for the reply..

Turns out it was the rotary feed option in the control def..

I had it set to degrees/minute.. should be Unit/minute..