4+1 Post Processor

[Devil]

Hello, how do I set up a 5-axis post-processor to move 4 axes in one sentence, not 5. The machine cannot move 5 axes at the same time, otherwise it can be in any combination but 4 axes at same time...

[crazy^millman]

1 hour ago, gubestiq said:

Hello, how do I set up a 5-axis post-processor to move 4 axes in one sentence, not 5. The machine cannot move 5 axes at the same time, otherwise it can be in any combination but 4 axes at same time...

Use the correct Machine and Control definition along with the correct toolpaths in Mastercam.

[Devil]

Can you tell me where I am going wrong ?

Mastercam 5 AXIS.mcam

Post.zip

[donglai]

On 2/12/2023 at 3:32 AM, gubestiq said:

Hello, how do I set up a 5-axis post-processor to move 4 axes in one sentence, not 5. The machine cannot move 5 axes at the same time, otherwise it can be in any combination but 4 axes at same time...

You should select the tool axis control with the output type is 4 axis and enter the tilt angle.

[Devil]

thanks for the reply