Using Predator with Mastercam

[savtav]

To Cadcam,

How do you go about using predator with mastercam to verify my nci files, Is it as good as mastercams verifer? Is There a dealer that sells it in Sydney Australia?

How can i get a demo set up to work with mastercam...Before i buy a full version

Sorry about all the questions

Regards sav...........

 

[cadcam]

Savtav we use a c-hook that integrates with mastercam.

Under "nc utility" were you have the Verify button it will replace that with the one for VCNC to be used.

The verify in the "OPS MANGER" will still work like before.

To use it do just like normal by setting up the stock info in the "job setup" then in the "ops manger" pick witch ops you want to verify then hit the button under "nc utilities" and it will take all the info and open VCNC and verify.

Then you can save the tool info and stock, then after you post the "gcode" use the tool info from before and check the gcode.

To see the demo you can down load it from my site then contact me I can help you.

And I can give you info about a 30day full trial.

------------------

jay/ aka cadcam

Precision Programming

cnc programming &

Predator reseller

email: [email protected]

web: www.ppcadcam.com

Mastercam forum FTP free file support

ftp://www.ppcadcam.com

User: mastercam

Pass: forum

[This message has been edited by cadcam (edited 06-01-2001).]