Mastercam 2023 Issues when Reopening files

[Kbacon]

I am on 2023 update 3, my toolpaths are all working correctly and I can post the NC. If I close the file and open it back up the toolpaths do not show on screen and will not let me regenerate. I can go into the parameters for each tool path and everything looks good but cannot backplot or post anything.

[#Rekd™]

Sounds like a graphics card problem. Are you running a system with two graphics cards (on board and a high performance GPU)?

[Kbacon]

21 hours ago, #Rekd™ said:

Sounds like a graphics card problem. Are you running a system with two graphics cards (on board and a high performance GPU)?

There is no on board GPU, just and Nvidea Quadro. It is strange that everything works normally until I close and reopen the file. Not having this issue in 2022 only when I switched over to 2023.

[#Rekd™]

Just for a double check run the task manager when you have the file open and look at the performance to see that the Nvidia GPU is listed.

Failing that you might try a re-install of  2023.