Cut Parameters

[Meryem]

I am trying to do a peck drill in Mastercam 2019 version, but I cannot change the parameters. When I give a 5mm peck, the settings that I cannot change below do not change automatically and the part pecks only once in the simulation. All of these parameters changeable on on the other computer. How can I set this?

 

[Kyle F]

I would first check your posted G code on the program, and verify the peck via a G83

There is a setting somewhere in mastercam simulation, like a check box, to simulate drill pecking. It could be possible yours is turned off. I have mine on but I know sometimes it can get annoying lol.

The settings below not changing is fine also, those ghosted out areas I mean. For my post I can put whatever I want in the value, but it just takes the first "peck" value and uses that anyways. For more control I have to use an advanced drill cycle.

[Aaron Eberhard]

How deep is the hole defined on the linking page?  If it's <=10mm, it's only going to peck once.  

The options available on the drill Cut Parameter page are controlled by your Machine Definition > Control Definition.