Reordered chain points??

[Harryman]

Is there a way to reorder chain points?

 

I had an ID lathe roughing operation that worked. I changed the stock to leave from .01 to .02. I did NOT mess with the chain!! I also created a couple mill operations on a Cplane created via 2 lines. I got the milling ops looking right and regened and reposted the lathe code without paying any attention to it cause it WORKED. I ran the lathe code and CRUNCHED the new Integrex because the boring bar did not retract. When I looked at the geometry, the retract point had moved before the chain in the geometry list THIS OPERATION HAD JUST RUN PROPERLY

 

Did I probably fat finger something that caused the geometry list to reorder??? Or is this a bug???

[Phil Orenstein]

Hiya Harry,

 

I emailed you , but not about this issue. Sounds like a bug to me, but I always run a backplot before I post to catch anything and mainly because I am pretty lame and forgetful. In fact I also do a verification every time. I'm that bad! Hope the Integrex is OK.

 

Phil

[Harryman]

Thanks Phil.