Verify Bug?

[ChrisD]

Okay , here goes.

I'm using 8.1. When I first got it I was able to goto job setup and use bounding box to set my stock size for verification. As soon as i was done, I was able to go to operations manager and select verify and the stock would be the correct size ,( I wouldn't even have to select "USE JOB SETUP VALUES" button).

After about a month of being able to do

that, I got a job that required a cylindrical stock setup. That worked out okay. After I went back to programming a rectangular shaped job. I went to toolpaths-job setup and setup my stock size. When I went to verify the program, I found I had to reset my stock sizes while in verify mode in the verify parameters, because the stock shown was way too big.

Is this a bug? I find it strange that this happened after I did a cylindrical job.

Is there a way around this that I may not see?

Thanks for any help in advance

Chris

 

[Brendan O' Regan]

chris

I noticed the same problem. Everything was ok until i changed from rectangle stock to round. When i changed back the stock size in verify is far too big. I thought it was just me so maybe there is a bug.

[ProductDevelopmentGuy]

You should be able to clean this up by deleting the VERIFY.PRM file that gets created in your MILLOPS directory, before running verification. That will set you back to the 'factory-installed' defaults.

PDG

[ChrisD]

Thanks PDG.

[Guest CNC Apps Guy 1]

On that note PDG, is there a way that you could create a button in the Job Setup or in the operations manager to clear out this *.prm file?