mpmaster?

[treej250]

Im currently using the MPA2100E.pst for a PC2100 control. I keep getting an error on the machine when the program starts to do a helix move. I notice the mpmaster.pst has some info in it concerning this. Do I just use the mpmaster.pst instead of the MPA2100E.pst? or do I need to copy some info from mpmaster.pst and paste it into the MPA2100E? Im not sure how to go about this.

Thanks for your help.

[mikee]

The 2100 control has a few different g codes then a fanuc. Mainly TLO and work offsets.

Try the mpvickers pst. It may need a change

It is setup for radius output on arcs. To output ijk you will have to edit the post at "general output settings"

Change arcoutput : 1

to arcoutput : 0

This post supports subs and 4th axis

hope this helps

mikee

[Allan Brown]

Mpmaster has some logic roughed out for the helical motion output required by the A2100 control. You can use this logic in another post that have been specifically written for that control.