tool change

[ngkim]

i wonder anybody can point out for me the tool change for a single cutter for a single toolpath posted using the fanuc.pst given.i always don't have the tool change(TnM6)although there is the tool length offset(G43HnZn)posted.

[Allan Brown]

Depends entirely on your post. In general, you'll have to search for 'ntools' or 'tcnt' or 'stagetools' and modify the logic. Generally if you are prestaging tools, the post will omit the first tool change which should already be selected from the end of the last program run.

[ 09-27-2001: Message edited by: Dave Thomson ]