bunding box problem (X)

[Elad]

Hi

 

When i use create-bounding box i get the window of the bounding box definition.

I unmarked the "all entities" and the bounding box window became stuck!

i can't do anything with this window now.not even close it.

only this window is stuck not all mastercam.

A bug?or did i do something wrong?

 

Thanks.

[Elad]

ok,

 

now i'm sure it's a bug!

after the bounding box window freezes on the screen, i clicked on create-bounding box again and nothing happend.and the i did it for the second time (create bounding box)i got a message : "exit current function before running new command. function not responding to MC_EXITFUNC request. Please report error to dealer." and when i clicked ok, the bounding box window works again.

This pattern works all the time. after it stuck click create bounding box twice, click ok when you get the error message and then it works again.

i will report this funny bug to qc.

[els_answer]

If you pick the entities you want to use for the bounding box and hit enter. It opens the window.

[cadcam]

Elad this not a bug. DO as Els has stated. if it locking up there is trouble with your puter buddy.

And long time no see.

 

All we had to do was put out a new software to get you to show up

[Elad]

Jay,

 

6548 posts?????

God, I missed a lot...

 

Good to see you are still around!

[cadcam]

I would say yes you have but it's all good.

So a big welcome home.

[Richard Thomas - Mastercam UK]

If you get to the point where the window "freezes" (it's waiting for you to pick geometry), then just pressing Escape will bail you out of the function altogether if you want to.

[tooljockey]

I have had this problem also, and the answers above work to get you out of it. But the other problems I am having with the b.box I can't figure out. I will click "display" in stock setup screen then click green check to exit and my b.box will not display, open stock setup screen again and "display" is NOT checked anymore!!

Also, my stock origin jumps to lower left corner???

[tooljockey]

I GOT IT!!!!

 

You must be in 3D for "display" to work on 3d model!