WoW thats alot?

[cadcam]

I am trying to tune up my computer a little,so i was checking sizes of folders.

Well my Mcam81 folder is 831 megs.

I do not save any Gcode or Geo files to this dir.

All files are saved on the server.

[Bullines]

Hmmmm...do you have metric samples installed, too? How about the commontemp dir, too?

[cadcam]

Well no Metric and the temp dir only have 1.5 Megs in it.

I think my problem is all the extras,

I Have every chook that there basically is.

[Bullines]

That could add up

[JAMMAN]

Just checked mine- under 250Meg and I do have all the samples loaded- 2d,3d and multax.

[Christian Raebild]

A full install would never reach those figures. Are you saving NCI files? that might be the cause of your problems.

[ 10-05-2001: Message edited by: craebild ]

[cadcam]

Well i looked it is on both work stations about 800 megs.

I for got, because of doing demos and stuff i have mill,wire,lath,design pluse all the chooks installed this adds up.

I have the boxs setup so i can just run one part or all the softwares by version (wire ,lath,mill)or level.

I all so have on these boxs

MC6.13a

MC7.2c

MC8.1.1

Mc8 router

MC9 beta

[Christian Raebild]

With all of that, then it would add up to the figure you gave.