G-codes

[Fred from Université de Sherbrooke]

Hello

I'm looking for all the G-codes and fonction of a Mori Seiki MH63 (with pallet charger) with Fanuc M6 control.

If anybody got it, please E-mail me the codes, It will be very appreciated. Thank's

[Guest CNC Apps Guy 1]

If you don't find them here, you can try calling Mori Seiki in Detroit at (248)553-2802 or the Chicago Office at (847)593-5400 or the US HQ in Dallas at (972)929-8321.

Hope that helps.

[d0gFartz]

I programmed an MH63 with a 15 on it for years and other fanuc 6,10,15 and 18`s,the codes on this site

http://www.emastercam.com/info/

will work fine,theres a few m codes for the pallet

changer that prolly arent on this site like

M60 is Pallet A in

M61 is Pallet A out

M62 is Pallet B in

M63 is Pallet B out

Even though its a 6 it oughta take say an M60 and

and run a predifined macro call for the lift and

seat of the pallet and such.

Heres a sample prog.,basically a little different

than some would do but just standard g code

O2801

F2801

(F1801 7700A MH63)

(3-9-95)

(G56X-24.380 Y-8.705)

#101=1(# OF TIMES TO ROTATE)

#102=#101(RESET # OF TIMES TO ROTATE)

#590=0(ANGLE OF NEXT TOOL START *** )

#599=0(RETRACT AMOUNT FOR CLEARANCE OF ROTATION)

M01

G91G28G0X0Y0Z0

T30(T30=8 IN. FACE MILL IN SPINDLE)

M6G90G56G0B#590

G90G56G0B#590

N301

#101=#102

#109=32(NEXT TOOL)

G90G56G0X2.65Y-5.5

B#590.

WHILE[#101NE0]DO1

G90G0X2.570Y-5.5

G43Z.05H30M3S3500

G1Y24.F60.T#109(T32=#5 CENTERDRILL IN WAITING)

G0Z.2Y-5.5

Z0

G1Y24.F60.

#101=#101-1

#105=#105-.023

#109=#0

END1

G49G0Z0M9

G91G28X0Y0Z0

M1

[cadcam]

Dogfartz did you write this out by hand?

[d0gFartz]

yeh,some is just common macro lines i always kept in a text file to copy paste to programs

[Fred from Université de Sherbrooke]

Thank's a lot d0gFartz