Help is needed, please

[JAMMAN]

I have some nc code I simply have to reverse post and backplot and save as geometry because I screwed something up. It is due today and I lost all the positioning. I found some rp files on the mc7 cd but have never used it before. If someone wants to e- mail me with a phone number no matter how far away I will call immediately. Thanks-

desperate Jim!!!!!!!!!

[cadcam]

Jammam,

You can call me and i will see what i can do for you.

661-945-5464 office were i am at this moment.

[JAMMAN]

Jay,

It was nice speaking with you via telephone. It helped me out a lot and I did get the fax. What I ended up doing (during a brainstorm) was editing the nc code, putting the I&J combos on their own lines, changing I to X and J to Y and reading it as an ascii file- saving as points. The geometry was a snap after that, and the customer will get her granite tops installed tomorrow. (yes, Sunday)

Again- thank you for your time and if there is ever anything within the scope of my knowledge I can help you out with; do not hesitate to ask.