HSM Area Clearance feed problem

[lynnz]

In using the new toolpath for Area Clearance, in the parameters for transition, there are 2 choices for feed rates. You can choose plunge or feed rate for either ramping in or helixing into the part. My problem is the default is plunge. When I change this setting to feed rate, I can hit the apply button and the green check to get out of the parameters. When I go back into the parameters, it is still set at plunge.

 

It appears it has the settings for a choice, but will only let you use the plunge choice. My work around for this was to change my plunge rate to a rate close to my feed rate.

 

Just wondering if others were seeing this happen??

 

lynnz

[Müřlıń®]

YUP!

[lynnz]

Thanks Murlin.

I've reported this to my VAR. Hopefully he'll send it to QC.

 

lynnz