Need help!!!

dnguyen · December 4, 2001

Hi all

The flange thicknest is .060 and 2.00 inches high to stop the flexing

and I want to cut the .200 thousand for step down inside then jump

to the outside cut .300 thousand to continue stepping down until

reach to the bottom of flange.

Is there anyway easier to do this with the Mastercam?

Thanks for help

dnguyen

[ 12-04-2001: Message edited by: dnguyen ]

December 4, 2001

The cut by depth switch in depth of cuts will accomplish this. This works for Pocket as well as Contour.

Your questin was a pretty vague so I'm just taking a guess with this one.

dnguyen · December 5, 2001

Hi Jame,

I want to thin the flange on the L chanel that is 2.00 inches high , I want to cut .200 thousand

on the inside of the chanel and then go to the out side and cut .300 thousand until I get to

the bottom of chanel.( aluminum chanel)

Thank you for your reply

dnguyen

P.S. This help take some of the vagues out of my question.

Welcome to eMastercam