EZ Burr Programming Question

[Kohler Joe]

I am using a EZ Burr tool to remove burrs on back side of a hole. I need to rapid tool in with a dead spindle, than start spindle and feed deburring tool out of hole. Can anyone tell me how I can accomplish this in MasterCam?

 

Thanks,

Joe

[Kyle Waters]

Joe, what control is this for? Do you want something like a G87? If I am not mistaken, the custom drill cycles should be able to accomplish this task.

[Kohler Joe]

Fanuc Control, I will give G87 a try. Thanks.

[medaq]

You are on mcam 10, but I am on 8. In 8 I can type in a little hand code using the toolpaths-next menu-manu entry

 

Basically it is a little section to type in a little hand code where you want. I am doing the same thing you are talking about right now. I m19 my spindle, g1 into my part, turn on spindle, run the deburr program, m19 and come out. I am sure mcam 10 has this feature but I can not tell you where it is.

 

Jim