Tabbing problems

[bhayden10]

Hello,

I am trying to use the square point tabbing method and have read a few threads on the subject and I think I have everything set right but I can't get the tabs to go where i want them. I've even tried to manually place them and they still go where they want. I made 6 square points in the middle of 6 lines on a contour and checked square point method.Is there something I may be overlooking?

Thanks!

[Josh Kinney -Elite Engineering]

as long as the level is visible (you can see the square points) and you place a square point on the line that your chaining with tabs set to square point you should be fine.

 

For tabbing I use partial/0.040" thick/0.25" width/midpoint/ramp/35deg.

 

I would look at your file but IT is a little tight around here...

[bhayden10]

Thanks Josh,

I knew it was something simple, I was regenerating my op after placing the points but I didn't go "repick" the chain and then regenerate it. Now its working like it should.