cutter comp not successful

[lennie]

I have installed X2 side by side xmr2 everything went ok until I tried to run an old program. I can open the file and back plot it. It does fine but if I regen the tool path I get a cutter comp error.

 

[Thee Dragracer1951]

most likely all the leadin's and outs got reset to 100%

[JohnA]

You may also want to check your comp settings. It may be set at "control" now instead of "wear" which is probably had it originally.

[lennie]

the lead in lead out is the same on both versions and the comp controls are both set to computer

[Glenn Bouman]

Do a Zip2Go on your file and put it on the ftp site so we can look at it.

[lennie]

I put a file "end cap top cut" on the ftp site in the folder mcx2 files. but i think i have something wrong with my control def. or machine def. because it is not just this file anything i open i get the same thing. but if i draw it and program it it works fine.

[Glenn Bouman]

Your file regens fine on my computer using your CD and MMD files.

[lennie]

I re-installed x2 this time I did not use the migration utility. I used the fadal format 2 4xmill.mmd machine def. I then created a square and created a toolpath around the out side with a 1" end mill it did fine. Then I put a radius on the top left corner and regenerated the tool path this worked fine. But I put the same radius on the lower right corner and I get cutter comp error. I can usually figure this stuff out but this has got me