Backplot an Advanced Multiaxis Transform op issue in X2MR1

[Mike Whitten CAD/CAM Contractors]

Hello,

 

I am having a problem when I try to backplot a “Toolpath Transform > Rotate Toolplane” a 5-axis toolpath that was done in the Advanced Multiaxis. When I select the Transform op and then hit backplot, the system reports an error that says “5AXMSURF” in the upper blue area and “Cut tolerance must be greater 0” in the lower area. If I delete the transform op and regen the Multiaxis msurf op all is well again.

 

This is very weird. Has anyone been able to rotate one of these toolpaths in X2MR1? It did this on two different machines. It works fine in X2

 

 

Thanks in advance!,

 

Mike

 

[ 05-04-2007, 09:32 PM: Message edited by: Michael Whitten ]

[Greg Williams]

Michael,

 

I get the same error when backplotting Advanced multi axis paths that were produced in X2 base release, I don't know why either

[Mike Whitten CAD/CAM Contractors]

Mine is happening in X2MR1 so I guess I am going back to X2 for this job. So this is also happening in X2 also? I have not tried X2 base release only the sp1 version.

 

Thanks,

 

Mike

[Greg Williams]

Michael,

 

No, I get this error in X2 MR1 with toolpaths that were created in X2.

[Mike Whitten CAD/CAM Contractors]

Got it

 

Thanks

[Mike Whitten CAD/CAM Contractors]

I just sent this in to QC.

 

If you keep hitting "Enter", the message with eventually go away depending on the amount of transforms. I am wondering if this will be OK for now? It seems like it would be?

 

Thanks,

 

Mike