X2 MR2 TOOLPATH CREATION PROBLEM

[balavigi]

hi

i am facing problem when create toolpath using 'T' slot cutter. the same was regen succesfull in x2mr1. but in x2 mr2 it gives the error message" no cut found-check tool, cut depth or roll tool at all edges" i tried in different ways but not created.then i tried in mr1 i found it is ok. please check. if you need i will send the file.

[Yogesh K. Raman]

what toolpath is it?

u can share the file in ftp for everyone to acces it.

[Sunder]

balavigi

 

---------------------------------------------------

no cut found-check tool, cut depth or roll tool at all edges

---------------------------------------------------

 

check your cut depth values, if you have translated the geometry so that your Z reference point might have changed

 

mail me the file; let me check or upload in ftp site

[Snehal Shah]

Just out of curiosity, is the toolpath you are trying to regenerate a surface finish contour toolpath ?