Speroni STP-34 Toolsetter

[haroldm]

Hi, i was wondering if someone might have any ideas about this problem. Basically the Toolsetter is posting Diameter offsets and our Fadal is Alarming on a negative tool offset, error is "attempting to switch sides without G40" Can the Fadal be set to accept Diameter Actuals? And do we need to use "wear" cutter comp or "control" to use offsets? I personally dont understand the question, but the toolsetter wanted me to ask, so if anyone has any insight into this questions, please let me know. Thank you.

[Dan@clover]

Harold, to use control cutter comp at the fadal, you need to use wear. Be sure your head#, tool#,Len offset, and dia offset are set to the right tool. Hope this helps.