Empty lines of code

[Clayton aj M]

Does anyone know why I get empty lines between the lines of code when I save a program from the machine onto my card?

 

I would like to get rid of the empty lines to make it easier to check when I go to use the program again...

 

Using Mastercam X

Machine is a Matsuura MAM700HG 4th axis

[spade117]

Got an example?

[Clayton aj M]

MY CODE LOOKS SOMETHING LIKE THIS

 

G01 F10.X1.0 Z1.0 Y25.

BLANK LINE

BLANK LINE

X3.0 Z1.0 Y25.

BLANK LINE

BLANK LINE

X3.0 Y30.

[Steve Biehl - Cimquest Inc]

an issue of what the control is saving as the eob character(s). Likely saving it off as a CR/LF/LF. If you were doing serial communications, you would setup CIMCO to auto adjust the eob to CR/LF. For saving to a memory card, you will need to find the parameters on the control to change the eob.

 

You can also use the CIMCO editor to remove blank lines.

[Clayton aj M]

Thanks for the help.

 

 

Where on the cimco editor is that icon?

[Steve Biehl - Cimquest Inc]

[Clayton aj M]

Thanks for the help

 

I thought they had cimco on the floor but they are using Mastercam X editor and the only thing that comes up under nc functions is

 

+0

+Z find XYZ EXTENTS

 

Sorry to waste your time Stephen