X3 Direct For Solidworks

[Lumpnut]

Hi All !

 

Whenever I try to use this add-in Mcam encounters a problem and shuts down. I get a "Fatal Application Exit" message that says " Unhandled Exception occured-Mastercam execution halted"

 

Any ideas how to fix it? I've ran the repair on both X3 and the Direct for Solidworks. I'm guessing it's just a bad install somehow or registry problem ???

 

TIA

[Brad St.]

Nunu, you made me just look to see here and I couldn't find the add on in SW. I know I had loaded it but our lovely IS department around here locks everything down nowadays when someone breathes funny. They had removed my admin rights, while i was unaware of not being an admin i tried reloading the mcdirect again to no avail. I had tried restarting sw two times. After getting my admin rights back and restarting the system "poof" there was the MC direct setup and it's working fine here for me.

 

SW 08

MC X3

 

Sorry, I dont' expect this to help ya but thanks for helping me get mine back and going =).

 

Good luck

Brad

[Lars Christensen]

What version of Solidworks?

SW2009 into X3

[Lumpnut]

Sorry forgot to mention that. I'm still running SW 08'