error message

[MARKECK]

getting an error of

 

cannot load c:programs filescommon filesmastercammcbitmap.ocx

 

can anyone help?

[gcode]

I've never seen that error before.

I checked my system and I have a

C:Program FilesCommon FilesMastercam

and it includes that file..

Have you tried a reinstall??

[alma999]

From:

http://messageboard.mcamnw.com/cgi-bin/ubb...c;f=20;t=000248

 

This error usually occurs right after installation of Mastercam X when you try to launch the program. The cause is usually some type of Antivirus/Firewall software running which stops these two files from registering properly during the installation. Try the following procedure to fix this error:

 

*Note: Before starting this procedure, disable any antivirus/firewall software on your computer.

 

1) Click on the Start Button > Control Panel.

2) Double-click on Mastercam X.

3) The Mastercam X Utility opens. In the large box in the center navigate to your local hard drive and into the WindowsSystem32 folder.

4) Click on the radio button "unregister component" and then click on the file MCBitmap.ocx from the list of files (This list may be very large so you may have to scroll a ways down).

5) Click on the "Apply" button.

6) Click on the radio button "register component" and then click on the file MCBitmap.ocx again.

7) Click on the "Apply" button.

8) A message should appear at the bottom of the window indicating that the control was successfully registered.

9) Repeat steps 4-7 for the file MClstCtl.ocx.

 

At this point you should be able to close out of the Mastercam X Utility and then launch Mastercam X.

[gcode]

nice link alma999