X4 2D Swept?

[MIKE_B]

Hi All

 

I'm roughing some slots with a 2d swept toolpath. I have done this many of times but this is the first in X4. I am using a 1/4 flat endmill and my tool will not cut to depth. It is staying .125 away from finished depth. I have tried with both tip and center comp with the same result. Just wanna know if i'm missing something simple or a bug?

 

Thanks

Mike

[MIKE_B]

Nevermind....my mistake I had my tool planes messed up

[Ocean Lacky™]

I had a similar issue....turned out that my wireframe wasn't trimmed properly. The arc that I was using for my across contour was a little long. Was only off by .001