Wire post help MPW-FA10

[savagkd]

Hi All. Please help a rookie.

 

With MPW-FA10.pst(updated from v-9) when I set MI1 to 2 "I want a G54" the nc output is:

 

%

H1 =.0067

 

N1 G90

N2 G54 X0. Y0.

N3 G00 X0. Y0.

N4 M20

etc.

 

I want:

 

%

H1 =.0067

 

N1 G90

N2 G53 G92 X0. Y0.

N3 G00 G54 X0. Y0.

N4 M20

 

Where do I start?

 

Thanks,

Keith

[Lars Christensen]

The post is most likely set up to do one or the other. 0-1=G92 2+=G54. It all takes place in pwcs I do believe, where mi1$ > 1. then G54 else G92. I do not have Mastercam running on this computer and I'm not sure if you can just "hard code" your G92 line in the pwcs without its getting repeated all over the place. Hopefully Roger shows up here minutes and share his great knowledge. but I will be happy to mess with it tomorrow at some point.